Arduino ESP8266 GPIO Wifi Shield:
ESP8266 WiFi GPIO Shield for Arduino:
The ESP8266 processor from Espressif is an 80 MHz microcontroller with a full WiFi front-end (both as client and access point) and TCP/IP stack with DNS support as well. While this chip has been very popular, its also been very difficult to use. Most of the low-cost modules are not breadboard friendly, don’t have an onboard 500mA 3.3V regulator or level shifting, and aren’t CE or FCC emitter certified….UNTIL NOW!
Standard pin interface to achieve full compatibility with the pitch for Arduino Uno, Mega, and so on. (Unless the standard size for Arduino, such as Nano, Mini)
3.3V power supply using advanced chip (with the official expansion board power chip CC3000 same), so 3.3V for Arduino board provided more accurate, so ESP8266 as official cc3000 chip work as normal, there is no gap.
It leads to a WiFi module power supply/service interface to facilitate developers to extend the power supply and maintenance.
Onboard ESP8266-12 stable industrial grade serial Wifi module, using an enhanced PCB antenna, signal better.
You can quickly switch DIP switch ESP8266-12 industrial grade Wifi stable operation mode (such as operating mode and upgrade mode) module, integrated serial chip, quickly flashing the firmware.
Built-in 5V to 3.3V TTL level converter to prevent high-pressure for Arduino TTL level of the WiFi module damage.
Onboard ESP8266-12 stable industrial grade WiFi module with a metal shield, immunity to interference .AND standard pitch leads to a stable industrial grade WiFi module all interfaces, enabling developers to easily develop deep.
کنترل از راه دور هواپیمای الکتریکی/مدل/چهار محوری و غیره
برای دستگاه های هوشمند خدمات شبکه ارائه می شود
مانیتور دمای خانه/رطوبت/PM2.5 و غیره
سوئیچ هوشمند و غیره